200x 3 LED RGB 5050 SMD Injection Module Strip sign shop front 6000MCD DC12V IP65

Reference: ST1065050CIRGB

On sale!

£ 180.00 tax excl.

Quantity

5 other products in the same category

Extensively applied in Backlighting for signage letters, concealed lighting and advertisement sign lightingEasy to install and operation.
Applicable for automobile decoration, contour lighting or border
Light up colorful home life ,DIY household lights for hallways, stairs, trails ,windows.
Light up colorful life hotels decoration use,Theaters, clubs, shopping malls, festivals and performances
Architectural decorative lighting,Archway, canopy and bridge edge lighting, Security lighting and Emergency

Voltage(V)	DC 12	Material of shell	Iron
Current（mA）	60	Color of the shell	Milk-white
Power（W）	0.72	Connecting cables	UL1007 20#
Emitting angle	120°	Connecting cable	Positive: yellow; single: green; Negative: white;
Luminous (lm)	--------	Cascade Qty(pcs)	200
Dimension(mm)	*85187*	Fix screw	---------
LED Qty(pcs)	3	Back glue	EVA sponge tape
Emitting color	Full color	Operating temp.	-40~60℃
IC mode	WS2811 256	IP rate	IP 65
Warranty	1 years	IP type	Epoxy resin

Parameters of light source：

Remarks of installation and application:

Don`t stick the surface of the light by sharp tools.
Don`t fix this product by sour glass glue or other soured adhesion; don’t operate or store this product in sour environment or the light will be vulcanized and the life span of the product will be reduced.
Drive this product by 12V DC switch power supply, and the power should be suitable for the quantity of the led modules; do not connect this product to the utility directly, or the product will be burnt up.
The total power of the led modules in series should be lower than 80% of the power of the driver, or the power supply will be burnt up probably, select the suitable thickness of the connecting cable according to the quantity of modules, and the connecting points should be wrapped by electrical tape.
The maximum cascade quantity of this product is 20 pieces for one strip, and the brightness of the two ends will be different because of the voltage loss when you increase the quantity of the module.