Voltage ： DC12V
Dimension ： 975*19.7*1.6mm
Power ： 11W
Connector ： 6PIN pin-board
Beam angle ： 165°
Weight: 10.3g/PCS
Lumens ： 1000lm
Standard Connection : 10PCS
LED Qty ： 10PCS
Drive model : Constant voltage
CCT ： 6000-7000K
Working Temp.: -20~60℃
Luminous efficiency ： 91lm/w
Storage Temp.: -60~80℃
IP rate ： IP33
Warranty : 3 years
1) The fixture works at 12VDC and is not allowed to use outdoor due to non-waterproof. Cuttable for single unit.
2) Use the power cable with2x1.5mm² above(Select appropriate power cable based on the loading current ),avoiding adverse result since too small line cause excessive heat on power cable.It can’t exceed 2 meters for power cable between power supply and fixture, otherwise the cable loss will increases power consumption.
3) At installation, please fix the pinboard to edge of the lighting box, insert rigid bar to pinboard and fix them with 3pcs ST3.0*6mm screw or plastic buckle. The center spacing between pinboard is 100mm.
4) Please install them as connection diagram showed, 10 pcs as a unit for standard cascade, each unit will be powered only one time, avoiding damage pinboard for excessive current.
5)Do not touch it or operate when powered and please use power supply with relating certification(with short circuit, overvoltage , over current protection)
No customer comments for the moment.
